Troops and Equipment.
Ensure that soldiers are briefed on environmental concerns/standards.
Demand situational awareness units, enemy, hazards, and environment.
Anticipate where maneuver density will be highest.
Use validated SOP to simplify operations.
Insist on accurate and timely spot reports.
Recognize soldier stress.
Rehearse always.
Time.
Maximize planning time.
Adjust pace and tempo.
Again, the best way to supervise and evaluate any type of controls or measures takes a wide-ranging effort.
By continually stressing environmental stewardship in everyday work duties and functions, you as the
supervisor can ensure that your subordinates integrate environmentally friendly and sustainable actions into
their daily duties.
PART C - PLANNING AND CONDUCTING ENVIRONMENTALLY
SUSTAINABLE ACTIONS AND TRAINING
When planning training exercises or preparing a petroleum facility SOP, always address the environmental
risks associated with the activity. Make sure that subordinates are aware of the risks involved with a given
exercise, mission, or other activity. Then, ensure subordinates are able to identify environmental risks
associated with everyday and out of the ordinary tasks.
In the absence of specific guidance (when laws, regulations, and policy do not necessarily apply), it
should be assumed that the toughest laws apply. This is the root of the Army's environmental ethic. Imagine
the worst possible scenario as a consequence of not acting morally right with regard to the situation.
PART D - VERIFICATION THAT HAZARDOUS SUBSTANCES ARE TURNED-
IN AND STORED IAW LOCAL UNIT POLICY AND APPLICABLE
ENVIRONMENTAL REGULATIONS
Using your local Hazardous Waste Management Plan, ensure that the following have been checked and
completed: DD Form 1348-1, the containers, fill capacity, markings, labeling, empty containers, and
inspection.
DD Form 1348-1. The Hazardous Waste Accumulation Facility Manager completes DD Form 1348-1.
The materials need to be properly classified, described, packaged, marked, labeled, and in proper condition
for transportation.
MIL-STD-129. The minimum requirements for the uniform marking of military supplies and equipment for
shipping and storage are provided in MIL-STD-129.
Containers. If a container is not in good condition or begins to leak, the contents are transferred to a
serviceable container or over-packed immediately. Only DOT-approved containers, compatible with the
materials being stored, will be used. A container holding waste is always closed during storage. Containers
holding waste are not opened, handled, or stored in a manner which causes the container to rupture or leak.
Containers holding ignitable or reactive wastes are located at least 50 feet from the installation's property
line.
All containers must be labeled with label marking pens, for example, the Sharpie extra-fine point marking
pen. Do not use ballpoint pens. Labels and markings must be replaced if they become damaged or lost.
Store containers to allow easy access to container labels. The type of label corresponds with the type of
waste. Labels are not placed over labels. All drums and drum-like containers are labeled as to their
contents. Empty drums and drum-like containers are labeled "empty."
5-5
QM 5097