Figure 2-2, Mobile petroleum laboratory.
Mobile Petroleum Laboratory PMCS. Ensure that the following general procedures are accomplished
by assigned personnel concerning PMCS of the mobile laboratory:
Inspect the petroleum lab body exterior starting at the rear to cover rear, curbside, roadside, front, top,
and bottom. Inspect for damage, tears, breaks, or corrosion.
Service petroleum laboratory exterior IAW TM 9-2330-362-14&P (Operator's Organizational, Direct
Support and General Support Maintenance Manual).
Inspect and service the Electronic Control Units (ECUs) in accordance with TM 5-4120-371-14.
Remove the overpack boxes.
Inspect laboratory for broken equipment or equipment that is loose and not secured.
Close doors and vents to determine if light leak exists.
Inspect doors for damaged or rotted seals and tightness of closure.
Inspect interior for evidence of water damage, fungi, mildew, or corrosion.
Inventory section contents against Components of End Item and Basic Issue Items Lists (TM 10-6640-
215-13, Appendix C).
Inventory consumable supplies contained in section (TM 10-6640-215-13, Appendix E).
Ensure that any damage or discrepancies are reported IAW AR 735-11 (Accounting for Lost, Damaged,
and Destroyed Property), and AR 735-11-2 (Reporting of Item and Packing Discrepancies).
2-19
QM 5183
Previous Page
