LESSON 5
PRACTICE EXERCISE
The following items will test your knowledge of the material covered in this lesson. There is only one correct
answer for each item. When you complete the exercise, check your answers with the answer key that follows. If
you answer any items incorrectly, go back to the part of the lesson that contains the information involved and
study again.
1. What is the purpose of the Scope section of the Calibration SOP?
A. To describe the purpose, use, instructions for completion, and disposition of forms and other record
keeping systems that must be followed.
B. To describe the specific responsibilities of all personnel assigned to the laboratory.
C. To describe the broad concepts of equipment calibration, proper record keeping, and training of
personnel.
D. To describe the purpose of preparing and maintaining the SOP.
2. Definitions are included in what section of the Calibration SOP?
A. Scope.
B. Record Keeping.
C. References.
D. Miscellaneous.
3. Internal C and external A calibration steps are found where in the Calibration SOP?
A. Equipment maintenance.
B. Procedures.
C. Record Keeping.
D. Responsibilities.
4. Once an item of equipment has passed C level calibration, what form must be completed and either attached
to the item of equipment or to the DD Form 314 and kept on file?
A. DA Label 80.
B. DA Form 2402.
C. DA Form 2404.
D. DA Form 2417.
5. Which form is required to record calibration due dates of petroleum laboratory equipment?
A. DD Form 314.
B. DA Label 80.
C. DA Form 2402.
D. DA Form 2417.
5-4
QM 5181